jakub96124
Active member
Testing scanning permissions
The following procedure will allow you to test if your permissions are set. When testing, use a computer outside the server's network and do not use any additional commands to login as an admin.
You need a telnet client to run these commands. Windows has one built in, which you can access by Start -> Run... -> telnet. Windows telnet client may need to be enabled via Control Panel -> Programs and Features -> Turn Windows Features on or Off and enable telnet client.
1. Open a telnet session. If it does not connect, your firewall is likely the culprit.
telnet IPADDRESS QUERYPORT
If through the windows telnet client: open IPADDRESS QUERYPORT
2. Select your server.
use port=JOINPORT ok not working
3. Test the permissions by running the following commands, in any order.
serverinfo ok tested
clientlist ok not working
channellist ok tested
4. If all of your commands worked, your server can be added.
There is an issue if the server does not return "error id=0 msg=ok" or server information as a response. Your TS3 server may be lacking permissions. First, ensure that you are running the most recent version of the server. Next, check the permissions as specified at the top. Next, if it still does not work look up the permission id's mentioned to see what they indicate.
The following procedure will allow you to test if your permissions are set. When testing, use a computer outside the server's network and do not use any additional commands to login as an admin.
You need a telnet client to run these commands. Windows has one built in, which you can access by Start -> Run... -> telnet. Windows telnet client may need to be enabled via Control Panel -> Programs and Features -> Turn Windows Features on or Off and enable telnet client.
1. Open a telnet session. If it does not connect, your firewall is likely the culprit.
telnet IPADDRESS QUERYPORT
If through the windows telnet client: open IPADDRESS QUERYPORT
2. Select your server.
use port=JOINPORT ok not working
3. Test the permissions by running the following commands, in any order.
serverinfo ok tested
clientlist ok not working
channellist ok tested
4. If all of your commands worked, your server can be added.
There is an issue if the server does not return "error id=0 msg=ok" or server information as a response. Your TS3 server may be lacking permissions. First, ensure that you are running the most recent version of the server. Next, check the permissions as specified at the top. Next, if it still does not work look up the permission id's mentioned to see what they indicate.
